Gift Stack Mould
Exclusive to Myka Candles & Moulds and hand-poured in Australia using premium platinum-cure silicone. Ready to be shipped.
This handmade mould is crafted from platinum-cure silicone and features a slit on one side to assist with unmoulding. To use, simply start by piercing a hole in the center of the mould where you want the wick to come out. Thread the wick into the hole and align the two sides of the mould together before securing with rubber bands. Pour in melted wax and allow it to cure overnight before carefully unmoulding the candle.
Please note that this mould is intentionally cut to make unmoulding easier. This, in turn, will leave a seam line on the candle, but it's appearance can be minimized by ensuring that both halves of the mould are aligned as perfectly as possible before use.
Platinum-cure silicone is known for its durability and tear-resistance. It can withstand high temperatures up to 230°C, but it is not recommended to expose them to excessive heat for long periods of time. In comparison to regular silicone moulds, moulds made with platinum-cure silicone are more long-lasting and have a shelf life of more than 30 years.
Unmoulding tip: Loosen the sides of the mould and then push down from the top of the mould while carefully pulling the candle out. This will keep the bow in tact.
Finished product: 15cm (H) x 5.5cm (W) x 5.5cm (L)
Wax volume: 170g
Cotton wick recommendation: 6 ply
All measurements are approximate and will vary depending on the type of wax used and how much fragrance oil is added.
Clean with warm water and mild soap after every use and store in a dust-free environment. Do not over-stretch or use any abrasive tools or fingernails.
Disclaimer: mould is poured and trimmed by hand and therefore may have some minor exterior imperfections.
Photo credit: @glowquest_australia