Gift Stack Mould

Exclusive to Myka Candles & Moulds. Made to order (up to 1 week processing time). 

A handmade mould using premium platinum silicone. This mould has a slit on one side to assist with unmoulding. Use the rubber bands provided to hold the mould together.

Pierce a hole in the centre where you want the wick to come out. Wick the mould and align both sides together before securing with rubber bands. Pour in melted wax and allow your candle to cure overnight before unmoulding.

All our silicone moulds are high quality, durable, and are able to withstand extreme hot and cold temperatures. However, it is not recommended to use excessive heat for long periods. 

Unmoulding tip: Loosen the sides of the mould and then push down from the top of the mould while carefully pulling the candle out. This will keep the bow in tact.

Specifications

Finished product: 15cm (H) x 5.5cm (W) x 5.5cm (L)

Volume: 170g wax

Cotton wick recommendation: 6 ply

All measurements are approximate and will vary depending on the type of wax used and how much fragrance oil is added.

Mould Care

Clean with warm water and mild soap after every use and store in a dust-free environment. Do not over-stretch or use any abrasive tools or fingernails.

Disclaimer: mould is poured and trimmed by hand and therefore may have some minor exterior imperfections.

Photo credit: @glowquest_australia