Exclusive to Myka Candles & Moulds and hand-poured to order in Australia using premium platinum-cure silicone. (Up to 1 week processing time)
This handmade mould is crafted from platinum-cure silicone using a 3D printed design. To use, simply start by piercing a hole in the center of the mould where you want the wick to come out. Thread the wick into the hole and align the two sides of the mold together before securing with clips. Pour in melted wax and allow it to cure overnight before carefully unmoulding the candle.
Platinum-cure silicone is known for its durability and tear-resistance. It can withstand high temperatures up to 230°C, but it is not recommended to expose them to excessive heat for long periods of time. In comparison to regular silicone moulds, moulds made with platinum-cure silicone are more long-lasting and has a shelf life of more than 30 years.
Finished product: 22cm (H) x 7cm (W) x 5.5cm (L)
Wax volume: 1kg
Cotton wick recommendation: 15 ply
All measurements are approximate and will vary depending on the type of wax used and how much fragrance oil is added.
Clean with warm water and mild soap after every use and store in a dust-free environment. Do not over-stretch or use any abrasive tools or fingernails.
Disclaimer: This design is 3D printed using PLA filament and therefore will have print lines on the finished product. Our custom moulds are poured and trimmed by hand and may have some minor exterior imperfections.